Back in My Arms Back in the Front Seat Back in My Arms Back in the Front Seat of My Car Again

Always vesture your seat belt when travelling in your vehicle. You must also comply with the legislation of the particular country you are in.

Make sure that the rear demote seat is locked in position correctly so that the rear seat belts will operate correctly. REAR BENCH SEAT: functions.

Incorrectly adjusted or twisted seat belts may crusade injuries in the event of an blow.

Use 1 seat belt per person, whether child or adult.

Even pregnant women should wear a seat chugalug. In this case, ensure that the lap chugalug is non exerting too much pressure level on the belly, but do not let whatsoever slack.

Before starting, first adjust your driving position, and then ask all occupants to accommodate their seat belts to ensure optimum protection.

Adjusting your driving position

- Sit well dorsum in your seat (having removed your coat or jacket etc.). This is essential to ensure your back is positioned correctly;

- adjust the distance between the seat and the pedals. Your seat should exist every bit far back equally possible while all the same allowing you to fully depress the pedals. The seatback should be adjusted so that your arms are slightly bent when you hold the steering wheel;

- adjust the position of the steering wheel.

Adjusting the seat belts

Sit with your dorsum firmly against the seatback.

The shoulder strap1 should be as close as possible to the base of the neck but not on it.

Lap belt2 should exist worn flat over the thighs and confronting the pelvis.

The seat chugalug must be worn as shut to the torso every bit possible. Eg: avoid wearing heavy clothing or keeping bulky objects under the belts, etc.

Locking

Unwind the chugalug slowly and smoothly and ensure that buckle3 locks into catch5 (check that information technology is locked past pulling on buckle3). If the belt jams, permit information technology to return slightly before attempting to unwind it again.

If your seat belt is completely jammed, pull slowly, but firmly, so that just over 3 cm unwinds. Allow it to return slightly earlier attempting to unwind information technology once again.

If at that place is still a problem, contact an canonical dealer.

Unlocking

Press button4 and the seat belt will be rewound by the inertia reel. Guide the belt.

™ Driver's seat belt reminder and, depending on the vehicle, front passenger seat chugalug reminder

This appears on the central displaysix when the ignition is switched on and if the commuter'due south and/or front passenger'due south seat chugalug(southward) (if the passenger seat is occupied) is not fastened.

Depending on the vehicle, if the seat is occupied and i of the seat belts is not fastened or becomes unfastened while the vehicle is moving at a speed over approximately 12 mph (20 km/h), the ™ alert lite flashes and a beep sounds for 120 seconds.

Annotation: an object placed on the rider seat base may, in some cases, actuate the warning low-cal and an audible warning.

Rear seat belt reminder

(depending on the vehicle)

The graphic 7 appears on the instrument panel when the ignition is switched on.

This informs the driver of the fastening condition of each of the rear seat belts every time:

- the ignition is switched on;

- opening a door;

- a rear seat chugalug is fastened or unfastened.

Agreement the graphic7:

- indicator dark-green: seatbelt attached;

- indicator red: seatbelt unfastened.

When the vehicle speed is below approximately 12 mph (xx km/h), the graphicseven appears during approximately 60 seconds every time i of the rear seat belts is fastened or unfastened.

When the vehicle speed reaches or exceeds 12 mph (20 km/h), if one of the rear seat belts is unfastened during the journeying:

- the ™ warning light flashes on the central display;

and

- a beep sounds for effectually 30 seconds;

and

- the7 symbol is displayed for at to the lowest degree lx seconds and the symbol for the seat concerned changes to red.

In all cases, ensure that all rear passengers are wearing seat belts and that the number of seat belts shown as fastened matches the number of rear seats occupied.

Adjusting the tiptop of the front seat belts

Press the push button8 to adapt the seat belt height, so that the shoulder strap1 is worn every bit shown previously. Printing push8 and heighten or lower the seat belt. Make certain that the seat belt is locked in position correctly afterward you have adapted information technology.

Rear side seat belts9

The belts are locked, unlocked and adapted in the same fashion every bit the front belts.

Rear heart seat chugalug

Unwind chugalug10 slowly from its housing, then fasten buckle11 into the corresponding black take hold of13.

Fasten sliding buckle12 into the corresponding red catch14.

Cheque that the rear seat belts are positioned and operating correctly each fourth dimension the rear bench seat is moved.

The post-obit data applies to the vehicle's forepart and rear seat belts.

- No modification may be made to the component parts of the originally fitted restraint system: seat belts, seats and their mountings. For special operations (e.g. plumbing fixtures child seats), contact an authorised dealer.

- Do not use devices which allow any slack in the belts (due east.g. clothes pegs, clips, etc.): a seat belt which is worn besides loosely may crusade injury in the effect of an accident.

- Never clothing the shoulder strap under your arm or behind your dorsum.

- Never utilise the aforementioned chugalug for more than than one person and never hold a baby or child on your lap with your seat belt around them.

- The chugalug should never exist twisted.

- Post-obit an accident, have the seat belts checked and replaced if necessary. Ever replace your seat belts as shortly as they show whatsoever signs of habiliment.

- When the rear bench seat is being put back, brand sure that the seat belts and buckles are correctly positioned then that they can be used properly.

- Make sure that the buckle is inserted into the appropriate catch.

- Ensure that no objects are placed in the area around the seat belt catch as they could prevent it from beingness properly secured.

- Make sure the seat belt catch is properly positioned (it should non be subconscious away, crushed or flattened by people or objects).

pattersongived1963.blogspot.com

Source: https://gb.e-guide.renault.com/eng/Zoe-ph2/SEAT-BELTS